Newsletter

RSS feed

No RSS feed added

Combination Vise With Aux Jaws Plans and Hardware Pack Maximize

Combination Vise With Aux Jaws Plans and Hardware Pack

 The Most Fully-Featured, Best-Working Model We've Ever Offered

Shopsmith exclusive offering of a set of drawings (plus a 74-piece hardware pack) for creating a sliding mounting base and 16 shop-made wooden jaws that you can build for your Quick-Acting Combination Vise to grasp a variety of different sized and shaped workpieces in any number of positions.

More details

556438

1 Item in stock for dispatch at this price

£ 129,50

     Quick-Acting Bench and Drill Press Vise

Use the Included T-Nuts To Attach It to Your Mark 7 or Mark V Model 520 510 or 505 Table Mount It Onto a Benchtop Using the Included Clamp

New! Quick-Acting Bench & Drill Press Vise Is The Most Fully-Featured, Best-Working Model We've Ever Offered

If you're a Shopsmith owner, you've probably already figured out that having a great drill press vise could be a BIG help for holding small workpieces while you bore holes, rout mortises and perform other operations with your Shopsmith set-up in vertical drill press mode.

One Vise or Two?

And, we're also guessing that you've run into situations where having a bench-mounted vise would be pretty handy, too ! But adding both of these tools to your shop can be a costly proposition. Small drill press vises with little in the way of features can run between $50 and $130 or more. Bench vises can easily exceed the $150 range.

Here's a Solution

This great combination vise offers 4" wide jaws that adjust rapidly with a pushbutton quick-release mechanism. It can be mounted easily to your drill press table (through your Mark V or Mark 7's sawing table insert or with our sliding T-Nuts (included). Or, you can also mount it to your workbench in any number of configurations (see photos) using the included bench-mount clamp.

You get a lot of versatility for about the same money as a low-cost drill press vise alone.

Shopsmith Exclusive!

Shopsmith exclusive offering of a set of drawings (plus a 74-piece hardware pack) for creating a sliding mounting base and 16 shop-made wooden jaws that you can build for your Quick-Acting Combination Vise to grasp a variety of different sized and shaped workpieces in any number of positions.

Sliding Base Let You Move and Lock Vise in Position Wherever You Want It
Grip Large Workpieces
Grip Round or Square Stock
Ensure Your Stock is Held 90° To Your Table Surface

Build these and you'll be able to • Handle Large Workpieces • Bore a Row of Holes Down the Length of a Dowel • Hold Round or Square Workpieces Vertically... and more.

Just a Few Ways You Might Use This Vise

On Your Mark V or Mark 7

  • Line drilling small boards or dowels
  • Center drilling small workpieces vertically
  • Routing slots & mortises
  • Hollow chisel mortising
  • Pen-making operations

On Your Workbench

  • Holding workpieces for hand sawing
  • Holding stock for hand planing
  • Drilling pipe, dowels or other materials

 

Note: Vise Color may vary from the item shown in the photos.