Combination Vise With Aux Jaws Plans and Hardware Pack

     Quick-Acting Bench and Drill Press Vise

New! Quick-Acting Bench & Drill Press Vise Is The Most Fully-Featured, Best-Working Model We've Ever Offered

If you're a Shopsmith owner, you've probably already figured out that having a great drill press vise could be a BIG help for holding small workpieces while you bore holes, rout mortises and perform other operations with your Shopsmith set-up in vertical drill press mode.

One Vise or Two?

And, we're also guessing that you've run into situations where having a bench-mounted vise would be pretty handy, too ! But adding both of these tools to your shop can be a costly proposition. Small drill press vises with little in the way of features can run between $50 and $130 or more. Bench vises can easily exceed the $150 range.

Here's a Solution

This great combination vise offers 4" wide jaws that adjust rapidly with a pushbutton quick-release mechanism. It can be mounted easily to your drill press table (through your Mark V or Mark 7's sawing table insert or with our sliding T-Nuts (included). Or, you can also mount it to your workbench in any number of configurations (see photos) using the included bench-mount clamp.

You get a lot of versatility for about the same money as a low-cost drill press vise alone.

Shopsmith Exclusive!

Shopsmith exclusive offering of a set of drawings (plus a 74-piece hardware pack) for creating a sliding mounting base and 16 shop-made wooden jaws that you can build for your Quick-Acting Combination Vise to grasp a variety of different sized and shaped workpieces in any number of positions.

Build these and you'll be able to • Handle Large Workpieces • Bore a Row of Holes Down the Length of a Dowel • Hold Round or Square Workpieces Vertically... and more.

Just a Few Ways You Might Use This Vise

Note: Vise Color may vary from the item shown in the photos.