Headstock unit Shopsmith Mark V Refurbished Maximize

Headstock unit Shopsmith Mark V Refurbished

Refurbished Mark V headstock-Latest UK specification

NO TRADE IN REQUIRED

Keep your old headstock as backup

The unit supplied will have been fully stripped and overhauled with new parts fitted 

The unit incorporates the latest on/off switch design with NVS* and dust protection

The unit will have been tested to comply with current Health and Safety standards

* NVS ( no volt supply) safety feature

More details

522405

£ 850,00

Refurbished Mark V headstock-Latest UK specification

NO TRADE IN REQUIRED

Keep your old headstock as backup

A complete headstock ready to run and give many years of service.

The unit will have been fully stripped and overhauled with all new parts where required.

The unit will have been tested to comply with current Health and Safety standards

Service overhaul carried out as follows:-

  1. Dismantle, clean and inspect all components
  2. Speed dial handle PASS FAIL
  3. Speed dial assembly casting PASS FAIL
  4. Quadrant PASS FAIL
  5. Remove motor. Clean and blow out dust with compressed air
  6. Test the motor and check wiring is undamaged PASS FAIL
  7. Check main power cable and plug  PASS FAIL
  8. Internal testing of the motor is carried out by specialist if required YES NO
  9. Check motor sheaves surfaces for damage PASS FAIL
  10. Check Lower belt for width, fraying or damage PASS FAIL
  11. Check control Sheave for damage and bearing function PASS FAIL
  12. Note upper belt tension position for stretch or fraying PASS FAIL
  13. Remove idler shaft and check assembly for wear PASS FAIL
  14. Inspect idler sheave assembly PASS FAIL  
  15. Dismantle on/ff switch, clean, file contacts, test forcontinuity PASS FAIL
  16. Check the Power Loss disconnect for function PASS FAIL.
  17. Remove & dismantle quill front assembly, clean, test inner/outer bearings, PASS  FAIL
  18. Remove Drive hub assembly, check for wear/rumble bothbearingsPASSFAIL
  19. Check Drive hub nylon bush for wear/damage PASS FAIL
  20. Remove & dismantle quill feed pinion assembly Check spring PASS FAIL
  21. Check, Clean, lubricate quill pinion assembly re-assemble with correct tensions
  22. Clean casting and check for cracks PASS FAIL
  23. Check for drive hub safety cover PASS FAIL
  24. Check for Safety and warning  labels  PASS FAIL
  25. Reassemble the unit for tests.
  26. Adjust the speed quadrant assembly for correct positioning and speed control
  27. Final checks and adjustments
  28. All tests complete. (pass)

Notes to client:

Using this checklist any items which fail will be replaced.

The report on the individual headstock will be supplied with the unit.

WARRANTY

For peace of mind the mechanical unit comes with a 6 month warranty on parts and labour.

The electric motor will come with a 90 day warranty which excludes misuse.

Electric motors can be burnt out quite quickly if used in an unsympathetic manner and such use will not be covered.