MARK V 505 and 510 Support Table Extension DIY KIT

UNLIKE the original very HEAVY item you can

Make a lightweight plywood table of your own choice of size

Shopsmith's Support Table Helps You Handle Long or Wide Boards Alone -- even Serves Double Duty as a Roller Stand

Shopsmith's support table helps you handle long or wide boards alone -- even serves double duty as a roller stand.

Shopsmith Support Table

Support table helps you handle wide or long workpieces by yourself with added safety and convenience. Just attach this support table to the infeed or outfeed end of your Mark 7 or Mark V worktable in a matter of seconds when you need to handle long boards or wide panels by yourself. The opposite end of the table is then supported by a leg that telescopes so you can match the work table height... then locks at the twist of a knob. The table tilts in unison with your Mark 7 or Mark V worktable.

*************NOT INCLUDED*************

The generous 24"w X 32"d X 1" thick top is covered with a low friction, easy-to-clean laminate and features two relief slots in the surface that allow your miter gauge bar to slide past the worktable edge without interference. A 14" wide roller top (also included) coverts the adjustable stand for use as a roller stand, when desired.

**************************

Perfect for ripping long boards or large panels, drilling, shaping, disc sanding or performing almost any operation on difficult-to-handle stock. Can also be used with Mark 7 or Mark V (models 510 or 520) floating extension tables.

THIS KIT Includes:  pivot brackets • Telescoping Leg Stand assembly • 2 foot connector tube • Hardware kit • Instructions

DIY ITEMS REQUIRED:- 24" x 32" x ½" plywood panel- 24" x 12" x ½" panel- some glue  and a router to cut slots for the mitre gauge bar. I will draw up some full instructions to include with the kit.