FLASH UPDATE


############

 

PLEASE NOTE:- Shopsmith Ohio has a new CEO & owner 01/01/2026

 

My website is still here for customers to see products and place orders.

 

Re-supply from Ohio should resume in 2027

 

Until then Parts will drop from sale as stock reaches zero

 

YES I can ship to the USA email me for details

 

With the increased demand in enquiries please be patient and expect delays in my replies.

 

############

 

    Home > Service & Spares>Worktable & Extention Tables>Mark V 510 Worktable & Extention Table>Shopsmith Rear Support table Part 31
    Shopsmith Rear Support table Part 31 Maximize

    Shopsmith Rear Support table Part 31

    518071 Shopsmith Rear Support table Part 31

    Plug

    Many listed parts may be part of a larger KIT and are not always available individually

    With all specialist parts orders 

    You are encouraged to email for assistance in order to get the right part.

    Please use the link under CONTACT US

    More details

    Customers who bought this product also bought:

    30 other products in the same category:

    518071 Shopsmith Rear Support table Part 31

    Plug- Only required on 505 510 520

    MARK V 505 and 510 Support Table Extension

    Shopsmith's Support Table Helps You Handle Long or Wide Boards Alone -- even Serves Double Duty as a Roller Stand

     

    Shopsmith's support table helps you handle long or wide boards alone -- even serves double duty as a roller stand.

    Shopsmith Support Table

    Support table helps you handle wide or long workpieces by yourself with added safety and convenience. Just attach this support table to the infeed or outfeed end of your Mark 7 or Mark V worktable in a matter of seconds when you need to handle long boards or wide panels by yourself. The opposite end of the table is then supported by a leg that telescopes so you can match the work table height... then locks at the twist of a knob. The table tilts in unison with your Mark 7 or Mark V worktable.

    The generous 24"w X 32"d X 1" thick top is covered with a low friction, easy-to-clean laminate and features two relief slots in the surface that allow your miter gauge bar to slide past the worktable edge without interference. A 14" wide roller top (also included) coverts the adjustable stand for use as a roller stand, when desired.

    Perfect for ripping long boards or large panels, drilling, shaping, disc sanding or performing almost any operation on difficult-to-handle stock. Can also be used with Mark 7 or Mark V (models 510 or 520) floating extension tables.

    Includes: Support Table with pivot bracket • Telescoping Leg Stand • Roller Top • Hardware and • Instructions.