FLASH UPDATE


############

 

PLEASE NOTE:- Shopsmith Ohio has a new CEO & owner 01/01/2026

 

My website is still here for customers to see products and place orders.

 

Re-supply from Ohio may resume in the near future

 

Until then Parts will drop from sale as stock reaches zero

 

YES I can ship to the USA email me for details

 

With the increased demand in enquiries please be patient and expect delays in my replies.

 

############

 

    Home > Service & Spares>Miter Gauge and Grip Handle >Shopsmith Mitre Gauge without Safety Grip
    Shopsmith Mitre Gauge without Safety Grip Maximize
    Next

    Shopsmith Mitre Gauge without Safety Grip

    505700 Mitre Gauge assembly without Safety Grip

    NEW LOWER PRICING

    (514374 was the former catalogue number)

    The Shopsmith Miter Gauge forms the basis for this complete system of work-holding and guiding devices. It offers a built-in scale that reads from 0° to 30° left and right... an adjustable “zeroing” pointer that lets you measure down to 1° increments... adjustable auto-stops at 0° and 45° in both directions... and a large, knurled knob to lock the gauge into position. A 1/4" hole runs through the face (left-to-right) for inserting the optional stop rod. 

    Will not fit ER.

    More details

    505700

    £ 110,95

    Customers who bought this product also bought:

    Previous
    Next

    20 other products in the same category:

    505700 Mitre Gauge assembly without Safety Grip

    Shopsmith Miter Gauge

     Shopsmith Miter Gauge

    The Shopsmith Miter Gauge forms the basis for this complete system of work-holding and guiding devices. It offers a built-in scale that reads from 0° to 30° left and right... an adjustable “zeroing” pointer that lets you measure down to 1° increments... adjustable auto-stops at 0° and 45° in both directions... and a large, knurled knob to lock the gauge into position. A 1/4" hole runs through the face (left-to-right) for inserting the optional stop rod. 

    505625 Mitre Gauge Safety Grip

      

    Attaches quickly to back and top of Miter Gauge for pistol grip convenience. One pound of squeeze pressure on the grip exerts five pounds of hold-down pressure on the foot. Can be set to grip stock up to 4” thick, with the centerline of the foot up to 2-1/2” out from the front of the face. For up-and-down adjustments, just loosen the large bat-wing knob and the foot drops down to engage the workpiece top. Tighten the knob and you’re ready to grip.

    Will not fit ER.