Home > Shopsmith Products>Routing>Shopsmith Mark V Router Table Shield Guard PART 19
Shopsmith Mark V Router Table Shield Guard PART 19 Maximize
Next

Shopsmith Mark V Router Table Shield Guard PART 19

515668 or 518479 Shield Guard Part 19 Plastic shield full design

  For 555658 and 555656 Router Tables

 A few styles of this shield are available. This one is the FULL shield. Designed to fit the alloy 515543 support 

If your shield Guard is missing or broken this can be ordered on its own

This item is for the Router table but can be used for your shaper as well

Use with the Full-Featured Router Table and Maximize Your Shop Safety

This space-saving device mounts directly on your Mark V router table to provide routing capabilities taking up minimal space. Just screw the post into the table in the designated threaded hole, adjust the shield arm and postion over your cutter. There is a vacuum attachment aperture in the top of the shield to directly mount your hose.

More details

518479-515688-518479

£ 34,99

30 other products in the same category:

515668 or 518479 Shield Guard Part 19 Plastic shield full design

  For 555658 and 555656 Router Tables

 If your shield Guard is missing or broken this can be ordered on its own

This item is for the Router table but can be used for your shaper as well

Use with the Full-Featured Router Table and Maximize Your Shop Safety

Shown below in use on the Mark V router table

Shopsmith Mark V Router Table

Full-Featured Router Table Maximizes Your Shop Space

This space-saving device mount directly on your Mark V to provide routing capabilities without taking up any more valuable shop space. Just drop the twin mounting-tubes into the extension table mounts on your Mark V, install and adjust the single telescoping leg on the opposite side and you have the foundation for a great router table.

The 23-3/4-inch x 18-inch laminate-covered table top features a drop-in center insert (with leveling shims), to which you attach your router motor's base. Its inlaid aluminum T-slot miter gauge channel will accept the Mark V miter gauge or featherboards and can be easily adjusted for a snug fit.

A series of threaded inserts in the table's surface accept the independently adjustable two-piece fence which can be locked into position with comfortable 3-wing knobs. Travel slots in the fence faces allow the attachment of shop-made faces.

The router guard offers a large 2-1/2-inch dust collection port on top and an adjustable brush on the back side to contain and direct dust and debris.

The large table surface also makes an excellent auxilliary support table for other Mark V operations. It can also be mounted on the Power Station.